Gearshift Position Sensor, Side Cover, And Control System Solenoids - Removal And Installation

• Transmission
  • Gear-shift position sensor, replacing (AW50/51 AWD; AW55-50/51SN)
    • Preparations
    • Remove the air cleaner (ACL) housing
    • Remove the transmission cable from the bracket and the lever from the transmission
    • Remove the gear-shift position sensor
    • Remove the connector from the transmission
    • Separate the connector on the transmission
    • Detach the socket for the gear-shift position sensor
    • Assemble the connector
    • Connect the connector to the transmission
    • Install the gear-shift position sensor
    • Adjust the gear-shift position sensor
    • Continued gear-shift position sensor installation
    • Install the transmission cable on the transmission
    • Install the air cleaner (ACL) housing
    • Checking diagnostic trouble codes (DTCs)
  • Gear-shift position sensor, replacing (AW55-50 1999)
    • Notes
    • Replacing the gear-shift position sensor
      • Removing engine compartment components
      • Removing the gearbox cable
      • Removing the gear-shift position sensor
      • Removing the connector from the gearbox
      • Disassembling the connector on the gearbox
      • Assembling the connector
      • Installing the connector on the gearbox
      • Installing the gear-shift position sensor
      • Adjusting the gear-shift position sensor
      • Installing the gear-shift position sensor, continued
      • Installing the gear selector cable
      • Installing engine compartment components
      • Checking the diagnostic trouble codes (DTCs)
    • Replacing the three-way catalytic converter (TWC)
      • Preparation
      • Removing the three-way catalytic converter (TWC)
      • Installing the three-way catalytic converter (TWC)
      • Finishing
  • Side cover transmission, replacing
  • Solenoids, control system, replacing
    • Notes
    • Solenoids, control system, replacing (AW50-42 1999)
      • Notes
      • Removal
        • Preparations
        • Remove the terminal from the transmission
        • Install the lifting beam and lifting hook
        • Raise the car
        • Removing the right-hand drive shaft
        • Remove the screws for the cable conduit and the ground lead bracket on the sub-frame
        • Remove the ball joint nuts (both sides)
        • Remove the bracket for the power supply cable to the heated oxygen sensor (HO2S) from the sub-frame
        • Disconnect the steering gear from the sub-frame
        • Remove the screws for the sub-frame support brakes, both sides
        • Lower the sub-frame
        • Drain the transmission oil
        • Remove the control system cover
        • Checking the solenoids
      • Information, versions and combinations
        • Solenoid S1
        • Solenoid SL
        • Checking resistance
        • Replace solenoid
        • Removing the control system
      • Reinstall the control system
        • Install the gear selector slide in the control system
        • Install the control system in the transmission
        • Connect the cable harness
      • Assembling the control system
        • Sealing the cover
        • Install the control system cover
    • Solenoids, control system, replacing (AW55-50 -2000)
      • Replacing and checking solenoids
        • Preparations
        • Check the resistance in S1-S5
        • Checking the resistance of SLT, SLS and SLU
        • Replacing solenoids S1-S5
        • Finishing
      • Replacing the control system
        • Preparations
        • Removing the control system
        • Replacing sealing rings
        • Checking the gear selector slider
        • Installing the control system
        • Finishing
  • Splines, greasing
    • Notes
    • Greasing the splines