Continuously Variable Transaxle (CVT)
- Precautions
- General Description
- Schematic and Routing Diagram
- Component Location
- Diagnostic Information and Procedures
- CVT System Check
- Malfunction Indicator Lamp (MIL) Check
- DTC Check
- DTC Clearance
- DTC Table
- Fail-Safe Table
- Scan Tool Data
- TCM
- Scan Tool Data Definitions
- Vehicle Speed (km/h/mph)
- Engine Speed (RPM)
- Primary Pulley Speed (RPM)
- Secondary Pulley Speed (RPM)
- Torque converter Slip (RPM)
- Primary Oil Pres (MPa)
- Secondary Oil Pres (MPa)
- CVTF Temperature (°C, °F)
- ECT (Engine Coolant Temperature, °C, °F)
- Battery Voltage (V)
- Throttle Position (%)
- Accel Actual Position (%)
- Gear Actual Ratio
- Lock Up Solenoid (Com) (Command, mA)
- Lock Up Solenoid (Mon) (Monitor, mA)
- Line Press Solenoid (Com) (Command, mA)
- Line Press Solenoid (Mon) (Monitor, mA)
- Secondary Solenoid (Com) (Command, mA)
- Secondary Solenoid (Mon) (Monitor, mA)
- Torque Converter Clutch (Release/Slip/Connect)
- Manual Gear Position (deactive, 1st, 2nd, 3rd, 4th, 5th, 6th)
- Shift Down SW (ON/OFF)
- Shift Up SW (ON/OFF)
- Manual Mode SW (ON/OFF)
- Transaxle Range (P, R, N, D)
- ABS Active (ON/OFF)
- A/C Comp Clutch (ON/OFF)
- Brake Switch (ON/OFF)
- Paddle Up SW (ON/OFF)
- Paddle Down SW (ON/OFF)
- Switching Solenoid (Mon) (ON/OFF)
- Switching Solenoid (Com) (ON/OFF)
- Visual Inspection
- CVT Basic Check
- Road Test
- Stall Test
- Time Lag Test
- Line Pressure Test
- "P" Range Test
- CVT Symptom Diagnosis
- MIL Does Not Come ON with Ignition Switch in ON Position and Engine Stopped (but Engine Can Be Started)
- MIL Remains ON after Engine Starts
- DTC P0602: Control Module Programming Error
- DTC P062F: Internal Control Module EEPROM Error
- DTC P0641: Sensor Reference Voltage "A" Circuit/Open
- DTC P0703: Brake Switch "B" Circuit
- DTC P0705: Transmission Range Sensor Circuit "A" (PRNDL Input)
- DTC P0707: Transmission Range Sensor Circuit Low
- DTC P0711: Transmission Fluid Temperature Sensor "A" Circuit Range/Performance
- DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low
- DTC P0713: Transmission Fluid Temperature Sensor "A" Circuit High
- DTC P0716: Input/Turbine Speed Sensor "A" Circuit Range/Performance
- DTC P0717: Input/Turbine Speed Sensor "A" Circuit No Signal
- DTC P0721: Output Speed Sensor Circuit Range/Performance
- DTC P0722: Output Speed Sensor Circuit No Signal
- DTC P0741: Toque Converter Clutch Circuit Performance or Stuck Off
- DTC P0776/P0777: Pressure Control Solenoid "B" Performance/Stuck Off/Pressure Control Solenoid "B" Stuck On
- DTC P0826: Manual mode Control Circuit
- DTC P0842/P0843: Transmission Fluid Pressure Sensor/Switch "A" Circuit Low/Transmission Fluid Pressure Sensor / Switch "A" Circuit High
- DTC P0847/P0848: Transmission Fluid Pressure Sensor/Switch "B" Circuit Low/Transmission Fluid Pressure Sensor / Switch "B" Circuit High
- DTC P0871: Transmission Fluid Pressure Sensor/Switch "C" Circuit Range/Performance
- DTC P0961: Pressure Control Solenoid "A" Control Circuit Range/Performance
- DTC P0962/P0963: Pressure Control Solenoid "A" Control Circuit Low/High
- DTC P0966/P0967: Pressure Control Solenoid "B" Control Circuit Low/High
- DTC P1706: Torque Request Communication Error from TCM
- DTC P1810: Lock up/Select Control Circuit
- DTC P1816: Stepper Motor Circuit Malfunction
- DTC P1818: Stepper Motor Performance
- DTC P1824: Calibration Data Reading Error
- DTC P1825: TCM-Valve Body Assembly Correlation
- DTC P1970: Sensor Ground Circuit Malfunction
- DTC P2763: Torque Converter Clutch Pressure Control Solenoid Control Circuit
- DTC P2764 : Pressure Control Solenoid "A" Control Circuit Low
- DTC U0073: Can-DTC
- DTC U0100: Can-DTC
- DTC U0121: Can-DTC
- DTC U0140: Can-DTC
- Inspection of TCM and Its Circuits
- TCM Power Supply and Ground Circuit Check
- Brake and Key Interlock System Inspection
- Repair Instructions
- Specifications
- Special Tools and Equipment