Traction Control System
- General Description
- Traction Control System (TCL) Diagnosis
- Introduction To Traction Control System Diagnosis
- TCL Diagnostic Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C1200: Front Right Wheel Speed Sensor (Open Circuit or Short Circuit)
- DTC C1201: Front Right Wheel Speed Sensor (Abnormal Output Signal)
- DTC C1205: Front Left Wheel Speed Sensor (Open Circuit or Short Circuit)
- DTC C1206: Front Left Wheel Speed Sensor (Abnormal Output Signal)
- DTC C1210: Rear Right Wheel Speed Sensor (Open Circuit or Short Circuit)
- DTC C1211: Rear Right Wheel Speed Sensor (Abnormal Output Signal)
- DTC C1215: Rear Left Wheel Speed Sensor (Open Circuit or Short Circuit)
- DTC C1216: Rear Left Wheel Speed Sensor (Abnormal Output Signal)
- DTC C1226: ABS Front Right Solenoid Valve (Pressure Holding System); DTC C1231: ABS Front Right Solenoid Valve (Depressurizing System); DTC C1236: ABS Front Left Solenoid Valve (Pressure Holding System); DTC C1241: ABS Front Left Solenoid Valve (Depressurizing System); DTC C1246: ABS Fear Right Solenoid Valve (Pressure Holding System); DTC C1251: ABS Rear Right Solenoid Valve (Depressurizing System); DTC C1256: ABS Rear Left Solenoid Valve (Pressure Holding System); DTC C1261: ABS Rear Left Solenoid Valve (Depressurizing System); DTC C1300: Front Right Cut Valve; DTC C1305: Front Right Suction Valve; DTC C1310: Front Left Cut Valve; DTC C1315: Front Left Suction Valve
- DTC C1271: Motor Circuit Failure
- DTC C1276: Power Supply Circuit Failure of Valves
- DTC C1340: Stoplight Switch
- DTC C1607: ECU failure
- DTC C1640: Variant Code un-writing/data Abnormal
- DTC C1860/C1861: Power Supply High Voltage/Power Supply Low Voltage
- DTC U1073: Bus off
- DTC U1100: ECM < M/T > or PCM < A/T > time-out (related to engine)
- DTC U1101: PCM time-out (related to transaxle)
- DTC U1120: CAN Communications System TCL Uncontrollable by Engine Malfunction
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication between the Scan Tool and the ABS/TCL-ECU is not Possible.
- INSPECTION PROCEDURE 2: ABS/TCL-ECU Power Supply Circuit System
- INSPECTION PROCEDURE 3: When the Ignition Switch is Turned to the "ON" Position (Engine Stopped), the TCL OFF Indicator does not Illuminate; INSPECTION PROCEDURE 4: When the Ignition Switch is Turned to the "ON" Position (Engine Stopped), the TCL Indicator does not Illuminate; INSPECTION PROCEDURE 5: The TCL OFF Indicator Remains Illuminated After the Engine is Started; INSPECTION PROCEDURE 6: The TCL Indicator Remains Illuminated After the Engine is Started.
- INSPECTION PROCEDURE 7: When the TCL Switch is Pushed On, TCL System is not Cancelled.
- INSPECTION PROCEDURE 8: TCL System does not Operate
- Data List Reference Table
- Check At Abs/TCL-Ecu
- Special Tools
- On-Vehicle Service
- Hydraulic Unit
- Wheel Speed Sensor
- TCL Switch